Laser Ninja Mini Keyboard Stand
Laser Ninja Mini Keyboard Stand
Laser Ninja Mini Keyboard Stand
Laser Ninja Mini Keyboard Stand
Laser Ninja Mini Keyboard Stand
Laser Ninja Mini Keyboard Stand

Laser Ninja Mini Keyboard Stand

Laser Ninja
Regular price
Sale price
$20.00 AUD
Unit price
Australian GST included, Shipping calculated at checkout.

The Ultimate Keyboard Display Stand

Keyboard stands are for showing off your keyboards. They are designed to be as unobtrusive as possible - the focus of attention should be your keyboard, not the unit that holds it up.

The mini can be assembled in two widths - 70mm and 140mm to suit different boards. The narrower 70mm configuration is ideal for numpads and macropads while the full 140mm width is ideal for 30-50% keyboards. It can also hold 60% boards but test carefully as the heaviest steel and brass boards might not be held as securely.

The green board show in the photos is a Nuphy TES68 and the smaller unit is a 3x5 Laser Ninja switch tester.


Backrooms Sale

These are the last keyboard stands in the mini size left. Only a handful remain.

These will be around until sold out. 


Key Features

6mm thick frosted clear acrylic
The material used is a premium 6mm thick clear frosted acrylic. The smooth satin frosted finish resists fingerprints and is easy to clean and appears on both sides.

The low key look of this material helps your keyboard stand out - the attention should be on the board and not what's holding it up.

Invisible custom cut 3M rubber feet
Custom cut clear 3M rubber feet are pre-applied on each stand, including where the keyboard rests. They are practically invisible and won't draw the eye.

Easy to peel protective film
If you've purchased laser cut acrylic before, you'll know it's a real pain peeling the brown protective paper off. The acrylic i've chosen comes with a very easy to peel clear plastic film. I could save a buck going to a cheaper material but I want the peel and build process to be as easy as it can be.

Assembles fast and packs flat
Keyboard stands do not require any tools to assemble thanks to the thumbscrew and square nut system. They assemble very quickly because there's better things to do. They are also packaged as flat as possible to minimise shipping costs, and can be transported around easily.

Designed and manufactured in Australia
The design of keyboard stands has evolved over time with the feedback of the enthusiast keyboard community, and are manufactured inhouse in Australia. Products are continually improved and feedback is always welcome. As a keyboard enthusiast, i'm here to design the best products I can for the community.

W: 70mm / 140mm
H: 108mm
D: 90mm


Visit Ninja's Site Here